Trolling motors are an excellent way to move the boat in the ocean, lake, and river for kayak fishing time. Kayak trolling motor gives the relief from using the hands to move on by padding the angle of the boat,and it doesn’t create the noise to disturb the fish,and their large splashes are one of the beneficial things to note down.
A Fisherman will take care of the hassle to keep their boat moving on, but while using the trolling motor, the user will use their foot to control the boat on the moving path. Here with the guide steps are listed to install the trolling motor on your boat and most of the fishermen recommended to follow https://www.trollingbatteryguides.com/kayak-trolling-motor/ steps to install kayak trolling motor on your boat.
What are the required tools items need to install the Trolling motor?
The tools as Drill, Handsaw, Wire Snips crimps, Tape measure, gloves, camera, tour attention, and eye projection.
What are the steps to follow while installing the trolling motor?
Step 1: Replacement of rudder
Replace the rudder on the motor to avoid the limbs to get tired and without the mess up between paddles and fishing line.
Step 2: Foot pedals
Use the provided red tube to connect the wire on the pedal without getting stuck. Take your own time and fix it properly.
Step 3: Wiring setup
Don’t change the tighten measure and avoid to loosen any parts on the motor. An engineer will know the measurement and built the motor with the correct tighten screws and the average of plastic and other parts. Visualize the measure of the motor and take lots of information about the wiring concept to make a draw out the wire placements.
Step 4: things to avoiddoing
Avoid using the wrong gauge wires to prevent the malfunctioning process and the failure of the equipment. Don’t use the casing products to store the wire gauge; the wire cutting steps result badly while working on going for fishing.
Step 5: method to mount the motor on the boat
On the high portion of the kayak, the access length of the trolling motor tube is connected with the down faced fibreglass post will get a stick. Without cutting the wires, cut the fibreglass tube carefully to look the streamline on the kayak. Remember salt water is a good electrode of electricity; make overall changes without the harmful methods.
Step 6: Clamps to cut and not to cut
The One cut and one not cut motors are used in a kayak. Measure the clamps measurement twice before cutting else keep the clamps off and then make the setup without any difficulties and hold the adjustment plate wisely.
Step 7: Setup for the gear selector
To use as a normal boat selector kept the original head part together and take off the extended wire and slaps. Use the long handle to access the desired direction with speed.
Use the above steps to mount the trolling motor most easily and try new ways to move on the water with faster hitting without cutting the wires like what you have mounted.